What is logic behind the use of Steel bar insted of gold
bar?
Answer Posted / dunstan
1. gold is expensive
2.gold tensile strength<< steel tensile strength.
3. we can't use pure gold bar(bcos it must mix with another
material)
Is This Answer Correct ? | 7 Yes | 3 No |
Post New Answer View All Answers
Why does the pressure increase under soil?
how to calculate quantity of cement,sand & aggregate for u.c.r / r.r masonry in cm 1:6
cement and sand required for one block of size 0.23*0.15*0.46
what motivates you to do a good job
If we are providing concrete joint in every 10m with water stopper in water tank wall then is it necessary to cut the steel at joint section?
Can anyone suggest how to determine scheduling of reinforcement of floor beams from Staad model,other than clicking each beam respectively 7 noting down the values ?
how much percent are used 20mm,10mm?
How should we design a brick column and footing?(note: no reiforcement to be provided) Can you tell me any reference book where i could possibly find this design? Plz help urgently
How much does the leaning tower of pisa lean?
how to tie 10 legged stirrups
how to calculate the material from ratio of work PCC, RRM,POINTING, RCC
is there any influence of water(used for mixing of concrete) on a weight of harndend concrete.
how much one carpenter can doing shuttering of slab in one day
which method is used in semi-rigid connection design??
Consumption of Binding wire for fixing of cover block in vertical surface