Interested to Buy Any Domain ? << Click Here >> for more details...
Why is statistics important in Industrial Engineering?
- 4 Answers
- 18598 Views
- I also Faced
- E-Mail Answers
Answer Posted / prabhat kartikey , me, iem, sg
industrial engineer work for optimum use of resorce For the
desired Quality leavel.
through Statical quality control tool (eg-TQC, SIX SIGMS,
JIT KANBAN) improve the Quality of product,
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
How to check DC Motor & SERVO Motor?
how can LED bulb indication work correctly without CT OR PT for 3 phase indication if one is cut then it will show the correct indication?
what is the standard time in production management ?
state the care that shall be taken while checking the diode
what is load capacity of 11 cm cylinder bor 100kg. pressor?
How the costs of the products and throughput time can be reduced while handling materials?
Why the thermocouple is a transducer an rtd is not a transducer both taking heat as a input and give millivilt and ohms.
what is difference between an encoder & resolver?
What is alternator & engine general protection?
Let’s say we live in a country that gets very cold, in Northern America / Europe. In winter, we monitor the ouside temperature, so that heaters can be switched on, inside the house. The idea is that, the colder it is outside, the warmer it should be inside. The heating side of things is just a heater that is either switched on, or switched off. Just from the information that has been given, please discuss this matter in depth. Provide reference to OPEN / CLOSED loop control, FEEDFORWARD / FEEDBACK control and MODULATING / ON_OFF control raised in the discussion.
What is purpose to use relay after digital output module?
How capacitor bank can prove superior to synchronous condensers w.r.t. power factor correction??
On what bases time study methods can be calculated?
What are the areas where I need to make improvement? (Please provide examples and suggestions for improvement).
What is the difference between automotive production and mass-production.?
