Interested to Buy Any Domain ? << Click Here >> for more details...
what is the significance of tan delta testing?explain the
theory?
- 7 Answers
- 37696 Views
- I also Faced
- E-Mail Answers
Answer Posted / er. ankush miglani 9718151073
Tan Delta is an effective tool in determining the
insulation condition of power cables using a VLF-TD System
Tan Delta measures the resistive component of a cable
system; a perfect cable is all capacitance and has no
resistance. The resistive component is caused by voids in
the insulation, electrical trees, water trees etc. The
resistive element causes the voltage not to lead the
current by 90° (something less) This is difference in angle
(less than 1° ) is the loss angle. The tangent of this loss
angle is the Tan Delta / or the tangent of the loss angle.
| Is This Answer Correct ? | 30 Yes | 12 No |
Post New Answer View All Answers
any body,pls tell me how to done relay coordination ? how to coordinate by TCC curve?how to read the tcc curve?
what is a power factor?
role of europe union in UK safety legistlation (electrical safety)
What do you understand by avr?
what parameters should we check to reduce the power bill
We have 90mX100m hangar with 16 no.of supporting pillar. It is required to provide power supply on all pillars. what is suggested earthing scheme for hangars.
Explain Energy and Power signals?
what is transformor oil gread
How equivalent impedance is calculated in thevenin theorem?
This is reqd for a 1MW Solar power plant..We have 2DC outputs from the solar panels Connected to 2INVERTOR panels.. Output from invertor is 3ph,280v,500kva,50hz.These are connected to individual ACB.This has to be stepped up to 11KV ,1250KVA SYSTEM.Now can I use (1) one more ACBTO GIVE A COMBINED OUTPUT OF 1000KVA,280V & STEP UP THE OUTPUT BY USING a single two winding 3 ph transformer 11kv/1250kva. or (2)use the two outputs and connect to one three winding transformer of above rating..Pls suggestwith details.
dear sir/madam i want to get some knowledge about RRB EXAMINATION(section engineer) 1- what is minimum cut off 2- wht portion is major portion . 3- can any body provide Sample paper. thanks & regards ashish
What is the basic principle of operation of alternators/dc generators?
if a number of plc s are there then how many modbus to be used
Why does curving the pole faces in a dc machine contributes to a smoother dc output voltage from it?
Why is the air gap between the pole pieces and the armature kept very small?
