WHY THE FREQUENCY IS 50 HZ IN INDIA.CAN WE USE SOME OTHER
FREQUENCY.IF SO WHAT IS THE RANGE AND WHAT WILL BE THE
EFFECT IN PRESENT POWER SYSTEM IF WE CHANGE THE FREQUENCY
AS YOU SUGGEST ?
- 32 Answers
- 48659 Views
- L&T, MCL, I also Faced
- E-Mail Answers
Answer Posted / eduard
it depends to equipment rated hz some equipment has
indicate 50/60HZ as you can see to the name plate... when
your equipment is 50HZ and its indicate as above it can be
use...
| Is This Answer Correct ? | 2 Yes | 15 No |
Post New Answer View All Answers
Type of motor stater detail and working detail
The knee point of a current transformer is normally unique and known.So why in the nameplate of a CT they put the minimum value like this Vk> 400v.
why r we using shell transformer for low voltage
what's the difference between 'shaft power demand' and 'BHP' , when we consider electrical load list.
What is control system?
How to calculat the ratio of HT\LT in energy meter
Hi.. I am a BE GRaduate in E&E. I have 8.5 Experience in Tendering & Estimation field. I have done SAP SD course few years back. But due to some reason i failed to get job in that field and continued my own field. Now I am thinking of changing into SAP seriously. How should i go ahead???
What are hrc fuses and where it is used?
How convergengr of nr method is not dependent on selection of slack bus and how gauss siedel method depends?
how commomn gate triggering is given for TRIAC ? other thyristor wont be efffected?
How the capacitance og capacitor volatage transformer is decided?
What is trip and closing coil in cb? Why need of them
What is stacking factor? What is its approximate value?
Refernce currents are to be generated using refernce cueernts how can this be done
What is nyquist contour?
