What is the difference between MCB & MCCB,
Where it can be used,
Answer Posted / venkatesh
* M.C.B. is the abbreviation of Miniature Circuit Breaker
and the M.C.C.B. is the abbrteviation of Moduled Case
Circuit Breaker.
* MCB can used low current circuit not more than 100A but
we can use the MCCB in high current ares more than 100A.
* In MCB, trip point cant able to change but in MCCB we can
chnage.
These are the main differnces b/w MCB and MCCB.
Is This Answer Correct ? | 90 Yes | 27 No |
Post New Answer View All Answers
How may I get the maximum current capacity for a particullar size Alluminum or Copper cable if there is compulsion to use?
What is the Diff. btw Manule Pull Station & Manule Abort Station Switches used in FM200 System??
How to size Air Circuit breaker (ACB)? What is the most important factors?
EXPLAIN WHY THE SURGE CURRENT RATING OF AN MCCB OR CIRCUIT BREAKER DECREASES WITH INCREASE IN THE RATING OF MCCB OR CIRCUIT BREAKER.
all interview questions with answers of ntpc (2000-2009
dear sir, i completed diploma in electrical in 2005, how i can get electrical supervisor liance in mumbai
what is Fault level? why it is calculated? how will u decide same for our plant?
A 100KVA SINGLE PHASE TRANSFORMER 10000/200V,50HZ REQUIRES 300V AT HV SIDE TO CIRCULATE FULL LOAD CURRENT WITH LV SHORT CIRCUITED.THE INTAKE IS 1000W.THE % OF REGULATION ON FULL LOAD AT 0.8 PF LAGGING WILL BE HOW MUCH AND THE SECONDARY TERMINAL VOLTAGE ON 0.8 PF LEADING WILL BE
Why computer humming sound occurred in ht transmission line?
What are the section criteria for cables. Now everywhere XLPE power cable is used or PVC is also used?.
When color of silica gel will gets change from blue to pink from Top to bottom?
Earth has zero potential then what would be the neutral potential ?
If short circuit ratio is high is it bad or good for a machine then tell the reason...
sir, Is their any measuring unit of knoking? please explian?
at meter room 50 hrc switch installed,but there are not get earthing proper,so what happen?and 11kv transformer out put going in to hrc main 400a three nog each? so earthing is require for all switch? (some customer made earthing at there home.)