Why use the VCB at High Transmission System ? Why can't use
ACB? Pls explain the ans.
Answer Posted / er. ankush miglani 9718151073
at high voltages the air may get ionized but the vaccum
doesnt. so dats why..........
Is This Answer Correct ? | 10 Yes | 4 No |
Post New Answer View All Answers
is oil viscosity affect on motor current?
what is the prinsiple of dc motor and construction and working ,application of dc motor.
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT SWITCH BOARD,MLDB,ACB,BUSBAR,ETC...?
Why efficiency of generator is higher than motor at a particular load?
What is the Designing & Selection Procedure for a DG/Transormer of rated capacity?
what is the interrelation between voltage current torgue speed and magnetic flux in case of different types of electric motors
sir i ve applied for hindustan petroleum and power grid india ltd..and the exams on feb 22.can you pls send model papers and tell how to prepare for those.i need to get into any of these for sure.....
why is the power generator connected as star earthed or star earthed through reactance and what its features ?
What are the different sign conventions used in electric circuits?
How to measure the Harmonic Distortion of UPS ie THD?
DG Earth Value?
the grid connection required for a 50 MegaWatt fotovoltaic powerplant is higher or lower than 35kv (high or medium tension)?
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
I am having a 1500 KVA transformer whose secondary current is 2086A and my connected load is 1000 KVA, I am having 400 KVAR APFCR for PF improvement what ratio of CT should i install in LT EB Bus to get optimum PF improvement?
How to test Alternator stability test for REF relay