Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / karthick
milling,grinding,broaching,shaping,planning,drilling and
all lathe operations
| Is This Answer Correct ? | 18 Yes | 2 No |
Post New Answer View All Answers
what are the parameters are selected while manufacturing a single cylinder block?what are the different kind of test is conducted on it so that it can withstand with all those condition which required to run the engine efficiently.which force is act when piston slide inside the cylinder.
State the laws of thermodynamics and its importance of in mechanical engineering.
what is diameter of a suction pipe?
What is gtsc technology?
What do you know about DG ,A,B,C, D, Check and safety of generator.?
why oil lift in screw chiller during change of climate.
what is the rpm of Turbocharger of Cummins KTA50G3 Diesel Engine?/ Normally What is the rpm of Turbocharger for any 1 MW Engine?
what will be the angular speed of a model of turbine whose dia is half of the real one and operating in 1/4 th of the head of the real turbine rotating in Nrpm.
What is pitting ? How it is caused ?
i am preparing for motor vehicle assistant inespector please send me old questions papers.
Hello Friends I had my ONGC test today,but it was very bad.But I would give certain suggestions so that u may not face he problem which i had. Be thorough with Electrical Technology.Generators.motors stators etc.There are 5 questions on that. There were also good no.of questions from Hydraulic machine and Production technology. Then 3 from Strength of materials.And remember the dimensional quantities.
Will anybody tell me about types and numbers of sensors in toyota corolla gli,honda civic and suzuki cultus vxri???
Why is thick steel wire stronger than thin steel wire?
Why do the radiators in your house click when you start the heating system?
HOW TO SELECT DG SETS AND DETAILED INFORMATION OF THE TERMS INVOLVED IN THE BROCHURES OF THE COMPANY?
