Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / binu
Dear Sanjay,
Hope you are adjusting 4mA with "Zero" screw and 20mA
with "Span/range" screw. I feel that you might have
adjusted the 3 psi with range screw.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
I need to know steps to Calibration Valve Guard......
Q1: Consider part of a control loop, which excludes the transmitter, consisting of a process, a controller and a control valve which may be represented by two dead times of 0.5 min each and three exponential lags of 0.8 min., 1.0 min. and 1.5 min. respectively. We wish to express this system as an overall first order plus dead time (FOPLD) model ie gain, time constant and process dead time. (We will see later that this is often done, to simplify controller tuning). For this exercise, gain is considered to be 1.0. (A) If the transmitter is a flow transmitter whose behaviour can be described by a dead time of 0.2 min. and an exponential lag of 0.5 min. in terms of the overall dead time and overall first order lag how can the system behaviour be approximated ? Overall dead time = Overall time constant = (B) If the transmitter is a temperature transmitter with a temperature sensor in a protecting well whose behaviour can be described by a dead time of 0.7 min. and an exponential lag of 15 min. how can the overall system behaviour be approximated now? Overall dead time = Overall time constant =
Which topics are covered in Process Control?
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
for oil & gas industries which zone is normally preferred? why? give its example?
What are the uses of orifice plates?
sir i m preparing for BARC but i am not getting any papers to prepare for this exam so please send me some sample papers to my i.d for the preparation of barc.
Can anybody please let me know Orifice plate sizing calculation formula and step by step procedure
which type of signal used in instrument?
Describe a time when you anticipated potential problems and developed preventive measures.
how to calibrate electro pneumatic positioner 8013 mil controls ltd ?gsr
What is the working principle of the magnetic meter?
How to calibrate an pressure gauge with yantrika test bench?
why we are using drum level control valve air to close?
What is sensitivity in vibration probes..?
