Interested to Buy Any Domain ? << Click Here >> for more details...
What is difference between Centrifugal and Recifrocating
compressor.
- 10 Answers
- 38272 Views
- I also Faced
- E-Mail Answers
Answer Posted / karthick
a reciprocating compressor is used to deliver air with high
pressure and in small quantity.it uses movement of piston
to craete vaccum inside the cylinder.whereas centrifugal
compressor uses blowers or fans to create vaccum and is
used to deliver air with low pressure and in large quantity
| Is This Answer Correct ? | 100 Yes | 18 No |
Post New Answer View All Answers
What are the 3 parts in indicator diagram?
Which pump is more efficient centrifugal pump or reciprocating pump?
Study the attached ACS 790 AHU and boiler GUI and refer to the video on the software usage, catalog and the step by step document (page 9) to perform the following task: List in a table form the controllers and all their connected I/O for the boiler and the AHU.
how can i replace annular plats in tanks
State the laws of thermodynamics and its importance of in mechanical engineering.
What is the formula for 1 HP of a two-cycle engine?
1.how do you purchase the sheetmetal,machined components for OEMS? 2.WHAT IS THE SYSTEM TO BE MAINTAINE FOR PURCHASE ACTIVITY? 3.HOW DO U DO THE PRICE NEGOTIATIONS & ITS PROCEDURES? 4.WHAT ARE THE PROBLEMS WILL FACE WHILE PURCHASING THE COMPONENTS& WHAT IS THE SOLUTION TO OVERCOME BY THAT ONE 5.WHAT IS THE NECESSARY NOTES TO MAINTAIN THE PO& RELEASING THE PO?
What is the difference between projectile motion and a rocket motion?
Name of any five measuring instruments?
hi,i am sekar.i am prepareing Assistant Motor Vehicle Inspector in TN.Transport ,if any one have previous year model pares or some questions,pls send me at gpsekar2007@gmail.com.
Dear Sir, i want to know formula for steel BAR/SQUARE/HEX/FLAT>LENGTH. SUPPOSE I PURCHASE 10 KG OF ROUND BAR OF DIA. 20MM SO WHAT LENGHT I GET. SAME FORMULA FOR HEX/SQUARE.?
Why are lng pipes curved?
What are the symptoms of broke piston ring?
Do you have idea about various methods of production of gears ?
Which factors influence the type of fracture in failure of a material ?
