Answer Posted / venkatesh kumar
Buscoupler means the Two diffrent source were using through
main panel it will isolate any one of source and if the
live source failed the panel 1 side compartment not get
supply weather ur using mechanical or Electrical interlock
for each Buscoupler
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
State superposition theorem?
Why wind turbines wheels rotate constantly
where the lexical paramater will use in fron end?
what is the size of cable for 15kw motor and 85 meter cable length using with vfd
How i can decide that HVDC line is best for transmission.
What is difference between slip rings and carbon burushes?
from where the self excitrd induction generator get the power?why is the voltage regulation is poor of seig?
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
WE ARE PLACE A NEW 75 KW MOTOR FOR JPF.IT IS CONNECTED IN M.C.C. WHEN WE ARE STARTING M.C.C.INCOMER IS TRIPPED.THEN WE ARE CONNECTED IN P.C.C WITH A MM30 RELAY PROTECTION THEN WE ARE STARTED MOTOR WILL RUN SMOOTHLY.
I don't understand why when we connect high voltage source in DC to electronic motor , we must add capacitor and resistor in parallel ? (I know that we use capacitor because we want to absorb the current that in the first second electronic motor in opposed with current course produce. ) what are the feature of Resistor and in such situation ?
What is the relation between frequency and motor rpm?
how slip power recovery system work
what is the purpose of bypass mode in energy lighting transformer?
Why is tan-delta test and capacitor measurement done on alternator?
what's the requirement of Dy11d0 connection of 3 phase transformer?what's use of it?