How to increse bearing capacity in soils (Stabilisation of
soils)
- 12 Answers
- 17861 Views
- I also Faced
- E-Mail Answers
Answer Posted / kiran babu t
According to IS code,each layer should not more than 200mm
and that each layer should properly compacted & rolled.
like this manner compaction should be done to increase the
bearing capactiy of soils.
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
2nd and 4rt angle elevation used in which country ?
how to convert cement, sand aggregate quantity from M3 to kg with full description?
WAP to print 1) 1 1 1 1 1 1 1 1 1 1 2) 1 2 3 4 5 6 7 8 9 10
Define What is aggregate?
2. In a container filled with each of the following materials, at a porosity of 40%, determine the upward gradient required to cause the quick condition (a) Lead shot with a G = 13.75; (b) Fibre beads with G = 2.15; (c) Sand with a G = 2.32
What is absolute pressure? How absolute pressure is calculated?
how to calculate Rate of analysis for 100 m3 Any ratio of concrete ? including labour
What is bylayer?
how can calculate the compressive strength of concrete cylinder by water cement ratio ?
How much cement is require in one sqft area in a G+3 residential construction.
How to calculate the cement consumption in RR Masonry in CM 1:8 for the foundation of Ground Level Reservoir
Soil bearing capacity formula
How to use of me trial wall plaster 6mm , 10mm par sqm. use in sand and cement ?
List out the types of roofs?
how to take concrete quantity for precast segment for viaduct project?
