Interested to Buy Any Domain ? << Click Here >> for more details...
what is power factor? whether it should be high or low? why?
- 11 Answers
- 16950 Views
- I also Faced
- E-Mail Answers
Answer Posted / das
it is the ratio of true power to apperent power. it has to
be ideally 1. if it is too low then cable over heating &
equipment overloading will occur. if it is greater than 1
then load will act as capacitor and starts feeding the
source. will cause nusence tripping
| Is This Answer Correct ? | 9 Yes | 2 No |
Post New Answer View All Answers
can anyone explain the star-delta motor control wiring ,which wire go where and how they operate?
any one guide me to reduce the power factor of diesel Generator from 0.97 Leg to 0.8 Leg.with out any change in my load.
how ups works ? various parts of ups and working principle
Dear Sir/Madam, I have one questions we have three steam turbines and one Gas turbine and our industry linked with the public network, we have protection system one of the protection is reverse power we can export just four MW only i would like to ask about how to calculate the reverse power. Thank you in advance best regards
Describe the colour rendering properties of i) tungsten filament lamps ii) tubular fluorescent lamp
sir i used 3 hp of motor for spraying pump, other home light and other home items which size of allminium pvc wire ix used
How to check the thermocouple is correctly connected to cable for K type? (i,e positive pole is connected to non magnetic conductor and negative pole is connected to magnetic conductor)
what is booster? and how it is connected in a circuit?
Work done in a free expansion process is
can anyone please help me to find the rupturing or breaking capacity in KA of circuit breaker (MCCB,VCB,ACB etc) of HT and LT side of a distribution transformer...please help with detailed step by step answer...thank you
Is it possible to measure correct value of earth resistance & cable insulation ristance with out disconncting earth lead & both sides of cable ends? If not, any other method to measure ER & CIR with out disconneting from the system.
our factory is going under construction mean time transformer 1000 kva 2 nos &load break swithch 12 kv & 4 nos 750 kva 2 nos & 380 kva 2 nos generator to be errcted.how to arrange earth pits &how to earth connect & neutral pit how to calculate in earth bit size.
How to check the cable fault / hv test of transformer cable.
Which capacitor is preferred for high voltage and frequency?
What is the end effect of linear induction motor ??
