why link is provided in neutral of an ac circuit and fuse
in phase of ac circuit?
Answer Posted / srij21
Link is provided at a Neutral common point in the circuit
from which various connection are taken for the individual
control circuit and so it is given in a link form to
withstand high Amps
But in the case of Fuse in the Phase of AC circuit it is
designed such that the fuse rating is calculated for the
particular circuit (i.e load) only.So if any malfunction
happen the fuse connected in the particular control circuit
alone will blow off.
Is This Answer Correct ? | 63 Yes | 8 No |
Post New Answer View All Answers
The 3 phase 400 hp 440 volt slip ring induction motor do not take one phase amps why ? The motor is running good condition
pls tell me function of closing coil of A.C.B.
does any one know where we can purchase insulation oil for high voltage oil filled cables
What is transient Phenomenon?
How the over load setting for HT Motors calculated-provided in Numerical Relay
why we r not earthed Control cable of C.T. terminals
what is the difference between general inverter and solor inverter clerly explain plz
Why Utility Distribution System in India is mainly at 11 kV? Why not Utility go for 33 kV?
For the requirement of a furnace of temperature range up to 1200 oC using silicon carbide rods, What is the required rate of transformer needed (please do it with all details)?
Please define ohm’s law for a.c (alternating current)?
what is basic difference betmeen normal & flame proof motor??
What is the maximum No. of out going mccbs permitted from an LV distribution paqnel? What is the ampere relation between incomer and out going switch gears/mccbs?
what is droop control?
what's the difference between abs/inc encoders. apart from the position remembrance what are all the other differences. and what's mean by grey code.
Please clarify 1. Icw: rated short circuit working withstand capacity 2. Icu: Rated ultimate breaking capacity 3. Ics: Rated service short circut withstand capacity 4. other specification of ACB