Interested to Buy Any Domain ? << Click Here >> for more details...
which type of motor is suitable for lift?
- 18 Answers
- 53246 Views
- NTTF Nettur Technical Training Foundation, Pothigai Power Solutions, I also Faced
- E-Mail Answers
Answer Posted / taufic
slip ring motor and Dc series motor
| Is This Answer Correct ? | 38 Yes | 11 No |
Post New Answer View All Answers
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
what are the analog quality input for protection function?what are minimum reqiments?
why output is out of phase in case of common emitter?
What is a signal flow graph?
EXPLAIN WHY THE SURGE CURRENT RATING OF AN MCCB OR CIRCUIT BREAKER DECREASES WITH INCREASE IN THE RATING OF MCCB OR CIRCUIT BREAKER.
direction of tarbine& genrator
could you measure current in parallel?
how can i determine the KVA/MVA rating of transformer precisely?? is there any standard test?????
Explain about technical and non technical losses in distribution system?
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
i have completed deee and i've (June2012-feb 2015 experience in electrical maintenance in pvt ltd company.company having HT & LT electrical power.how to apply electrical C-license ,NOW I was resigned my job,what are requirements of applying for c-license
Dear sir, my knowledge about cable size determination is limited. Though I read examples I could not calculate the Cable size required for electric driven pump 40 KW, 380 Volt, 50 HZ, 50 meter from transformer and it is three phase star delta starting. Please help as there is no one in my surroundings to help.
in a solar power plant,we are going to step up the voltage 350V to 33kv, and to 132kv GSS. i want to ask that if it is possible that 315v/33kv is not possible because we also use 315v/11kv. or it should be 415v/33kv? is it effects generation or losses? the second question is-generation is depends on LV winding? or LV winding design for generation voltage?
how can found motors folt current ? how can disided circuit breakers caoicity and breaking capicity ?
if 3400kw slipring motor rotor shorting done and motor started on mv drive ,what will be the rotor shoring current
