Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference between MCB & MCCB,
Where it can be used,
- 22 Answers
- 144645 Views
- ACB Group, Badve, Bajaj Electricals, Hensel, Siemens, SR, I also Faced
- E-Mail Answers
Answer Posted / balakrishnan
MCB is normally used for small loads like in DBs, MCB can
only protect loads from over current, it is available upto
100A.
MCCB is having some special characteristics over MCB. It
protects loads from over current, short circuit current and
earth fault protection. Moreover it is available in all
ranges (16A to 3200A).
MCBs are used mostly in DBs, MCCBs are used for all SMDBs
and MDBs.
| Is This Answer Correct ? | 111 Yes | 34 No |
Post New Answer View All Answers
A ray hit a smooth regular surface at an angle of 20 from the normal. Calculate : 1. The angle btw the incident and reflection ray. 2. The angle of deviation.
Explain marx circuit.
what is sustainable current of any conductors . a bare busbar or pvc cable has different sustainable current .
lamination figures
iam using DM 3251 voltmeter(1 percent accuracy)for 11KV system PT ratio is 11KV/110V.can anybody explain what is the max and min voltage deviation.
Could the power factor on electrical system can affect the registration of the kwhr meter or the CT/PT?
A low wet bulb temperature indicates
why induction motors are rated at 0.8 power factor.
Why is back emf used for a DC motor? Highlight its significance.
What is boucholz relay and the significance of it in to the trformer?
What is the rating factor for copper cable ( Specific value according to the type of laying ) & the voltage drop?
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
sir i have a car stereo system and there is jack on him so can u tell me a way to find out their power terminals on the jack or on the circuit board"
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%
i have completed deee and i've (June2012-feb 2015 experience in electrical maintenance in pvt ltd company.company having HT & LT electrical power.how to apply electrical C-license ,NOW I was resigned my job,what are requirements of applying for c-license
