Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ramesh pachamal
An induction generator is nothing but induction motor. if
the motor run more than the sysnchronous speed ie means the
slip goes on positive side it will feed the supply to same
feeder. but the excitation should be same to maintain.
| Is This Answer Correct ? | 4 Yes | 8 No |
Post New Answer View All Answers
The size and construction of bushings in a transformer depend upon?
Pl.brief me any electrical major fault you have rectified.
What is load boxes ?
What is T’Q and X’Q and X’D ? and what is saturated as well as unsaturated ?
how to select diiferent power transformers of same capacity on no load loss and full load loss by economical point of view.?
operation of diesel generator
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
What is the basic principle of operation of alternators/dc generators?
how to synchronize 3 phase slip ring induction motors of different ratings.
What is main cause of cable's terminal point burned in Lug on high temperature although lug and cable selection is ok as per stantard and also tightness is ok as per situation. so please take in deep and tell correct answer thanku.
How to reduce -234126219.6403 MVAr generation and by what?
block diagram of 2 ups system connected in parallel mode?
how wecalculate breaking capcity of acb mcb mccb .explain with example
if we have 320KVA Genset kindly advice how much load we can put it.
How good are you in resolving the commercial issues to Employer's advantage?
