Interested to Buy Any Domain ? << Click Here >> for more details...
why transformer ratings in kva?
- 99 Answers
- 234260 Views
- Bhel, College School Exams Tests, DOW, Emco, Esab, GE, KCP, PGCVL, Sodexo, TCS, vtps, Wipro, I also Faced
- E-Mail Answers
Answer Posted / vijay saharan
the cu losses rating in curent and iron losses rating in
voltage so the both losses are trnsformer and this is the
cause trasformer rating in kva.
| Is This Answer Correct ? | 10 Yes | 5 No |
Post New Answer View All Answers
What is the diff. between single compression and double compression gland
Can clean earth cable be considered as low current cable
Is vtg is controlled by the resistor? if else how much?
WHAT IS THE FORMULA FOR CALCULATING CURRENT RATING(DIRECT IN GROUND OR AIR) OF ARMOURED(XLPE) CABLE OF 4C,16Sqmm?
What is the difference in calculating size of AC cables compared to calculating size of DC Cables? Usually DC Cables are larger than AC Cables although they have the same ampacity. Why is it?
we have require a Motor (1500kW, 6.6kV, 50Hz) which shall operate at 1500rpm during 30min and after it shall run on 500rpm during 15min. The same cycle shall be repetitive during the whole working days. Which method is best and economic to achieve such type of task. VFD, VVFD, Pole changing motor etc.
During underground cabling in landscape area what did we cover the cable with to prevent the electric shock & protect the cable?
WHY DO VOLTAGE TRANSFORMERS FAIL DURING EARTH FAULT IN THE DELTA CONNECTED 6.6KV ELECTRICAL SYSTEM
There is any especial requirement for motor to drive through with VFD?
salam,hi, i need to know what the spesification of 300amp msb...
Why in 6 KV XLPE cable termination kit used and why not in 380 V xlpe cable same is not used
my question is how to answer the question "you are from b.tech eee background and why do you want to go for banking
Why we use duplex coil and hook switch in telephone system?
what is the ground fault relay,which purpose it will be use,clearly tell me plz
Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example?
