Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference between MCB & MCCB,
Where it can be used,
- 22 Answers
- 144641 Views
- ACB Group, Badve, Bajaj Electricals, Hensel, Siemens, SR, I also Faced
- E-Mail Answers
Answer Posted / a.ramaprasad
MCB - MINIATURE CIRCUIT BREAKER
MCCB - MODULE CASE CIRCUIT BREAKER
MCB RATING : 63 AMP (MAXIMUM) i.e. in the form of tpn(
THREE PHASE + NUETRAL)
MCCB _ 63AMP (min.)
MCB IS USED WHERE LOAD IS LOW BUT MCCB IS USED WHERE LOAD
IS HIGH AND USE AS INCOMER.WHILE THE MCB IS USED FOR
OUTGOING.
Addition to the above answers :
Now a days MCB' are avialble till 125 Amps too.
Many of distribution board use MCB as as both incomer and
out going. Normally recommended for three phase input and
single phaseout put , though it is used for 3 phaseinput &
out put.
Another important factor in MCB is it's breaking capacity
is limited up to 16 kA only though earlier it was limted
up to 9 and 10 kA only.
| Is This Answer Correct ? | 105 Yes | 57 No |
Post New Answer View All Answers
any one can explain the stages of a knee point which is taken during ct magnetising curve.
What is meant by analogous system?
how much value of resistance should connect to 15 kw, 6 pole 3 phase slip ring induction motor having RV-240, RA-42.
What happens if we run alternator on under frequency?
why we use single core 630mm2 cable for transformer secondary side
If you don’t have coal, salt and copper, then how would you earth your connection temporarily at a camp site.?
why ct ,cvt should be stored in a vertical position?
I have an existing old MCCB. ABB Model SACE, the rating are: Ue = 660 volts, Iu =1250 Amps, 3 poles, Ith (max) =800 amps at 45 deg C. I need a circuit breaker for my 3 phase motors, 380 volts 60 hz. the supplier required the minimum ampacity of the breaker to be 911 amps. can i use this breaker with rating of Iu =1250 amps but Ith = 800amps maximum?
Sir, I m 3rd year student 4m DCE and want to do internship in siemens or l&t or any other mnc related to electrical engineering. please tell me the procedure 4 same and oblige me
I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.
thyristor controlled APFC panel design parameter?
substation+ plc system
how does it help for selection of a transformer.
Why the earth to phase voltage is high 250 compare to other two phases
Define piezo-electric effect?
