Why used in layer by layer charcoal and salt used in earth
pits.
Answer Posted / vijay
its because Salts are ionic compounds composed of cations
(positively charged ions) and anions (negative ions) so
that the product is electrically neutral (without a net
charge), and these are the electro-chemical properties that
make them suitable for buffering of electricity from the
copper rod to earth's soil, they work best when they are
dissolved in water becouse that is when the ions are
produced.The layer of charcoal and salt helps to maintain
low
resistance for earth fault currents.Because of ionic
behaviour of salt and charcoal they will maintain moisture
content around the earht pit.
Is This Answer Correct ? | 53 Yes | 5 No |
Post New Answer View All Answers
Explain the propagation of harmonics in the network and influence of phase angle of harmonics.
HOW DO I CALCULATE THE SETTINGS FOR THE DIFFERENTIAL PROTECTION OF A 12kV/6.6kV, 6MVA,DYN11 XMER WITH PRIMARY SIDE CTR 400/1 AND SEC SIDE CTR 600/1?
I am abt to give IOCL intrv.Plz sir guide me for IOCL intrvw (Electrical).Which subject to be consider. questions are generally asked from which subject.Plz help me out.
for a 400kv t/m line with 10 ampere current will corona occur?
why the earth is taken minimum in supplying? wather it the proportional factor to getting work any equipment or a power plant?
how to decide no of electrodes for 1600A LT Main incomer panel
in ring main system we use the isolater b/w transfer bus and main bus if we r not use isolatar than wat will be the effect in our sys.
What is a single phase autotransformer?
What is the difference between solid grounding and impedance grounding?
Why mostly the HV side of transformer has Delta?
What is “pu” in electrical engineering?
where lt & ht capacitor used
how to compute kvar in substation feeder to improve power factor and sending voltage
Is it possible to connect a safety device in to parallel?
What is the IS standard for MCCB to be use (As per capacity of AMP)& for ACB also.