Answer Posted / joseph
Calculating Power Factor at LT or HT side is the same, as
P.F. is simply the ratio between the Active Power and
Apparent Power. Hence, if you have got both these
parameters then just divide Active Power by Apparent Power
(kW/KVA or MW/MVA as the case may be.)
Is This Answer Correct ? | 26 Yes | 2 No |
Post New Answer View All Answers
Thermal withstand capability under full short circuit conditions, in terms of number of times of occurrence of short circuit and corresponding anticipated percentage reduction in transformer life.
Testing report of Earthing of 3.15 MVa PTR.
How to decide the size of the capacitor for a single phase induction motor say 2 HP ??
how to setting voltage RTCC panel
what are the range of memory address in plc for L&T lx7 4A
what is the string efficiency
What is the basic of DTH.
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
What is acsr cable and where we use it?
how u measure/calculate renge of capacitor,capacitor has no any rating tag.what is the theory of measure of capacitons.
does any one know where we can purchase insulation oil for high voltage oil filled cables
in control scheme dc logic wiring commonly using negative loop,what is the reason?if we use positive looping what will happen?
What is the lockout relay
Is there a diode made that works with AC 120 volt 20 amp? If so can it completely stop all current flow in 1 direction at all times?
i have been tasked with a design of protection, metering and control(PMC) relay panel extension to accommodate all PMC relays.There is an already existing panel where this one will be built.What are the design aspects for this kind of project? thank you.