Answer Posted / debashisdb
Most Industrial drives have variable speed application
(fans, pumps) where the initial speed of the load is
normally very low and increases gradually.
The induction motor used for the purpose will have
specified starting torque & speed as per the torque-speed
curve of the motor. The speed is normally very high
compared to the load requirements at start. So by vfd it is
possible to control the speed of the motor according to the
loading requirements.
Since Power is proportional to cube of speed, control of
speed saves a lot of power requirement.
| Is This Answer Correct ? | 13 Yes | 2 No |
Post New Answer View All Answers
what r the checklist while installing a 380 kva DG set
What is the basic rule for block diagram reduction technique?
how to compute kAIC? with formulas...
how to calculate the power factor when instantaneous voltage and current has harmonics in it ?
WHAT IS START TO INDUCTION MOTER IN STAR TO DELTA OF >5HP ?
transformer spections :: input voltage 0-110-230v; output volage 0-10-12-14v; amp=3A using CRNO CORE, capcaity=50VA primary turns = ? ; secondry turns =?
if in 3-phase system voltage=440V,frequency=60Hz, current=400A. then if it is single phase then current=? and if it is single phasing then current=?
how to test the turn ratio of 3 phase transformer using volt meter shoe the curcit diagram.
Explain about p.t?
WHY RATING OF VCB NOT LESS THAN 630A
What is boucholz relay and the significance of it in to the trformer?
how to calculate current and voltage in a same circuit?
what is Insulation monitoring device. where it is used? (in switchgear room or control panel or in field equipment)
what happen when increase or decrease size of lamp,light.glass.
How to calculate pitch, gauge of winding wire, and No. of turns for 30HP, 3 phase, 4 poles 50Hz, 380V induction motors
