what is the difference between LATCH and FLIP FLOP
- 4 Answers
- 5865 Views
- Wipro, I also Faced
- E-Mail Answers
Answer Posted / sriram
flip flop is a sequential device that samples its input and
changes its output at time determined by clocking signal....
where as latch is d one that checks its input and changes
its output at any time independent of the clocking signal......
| Is This Answer Correct ? | 8 Yes | 2 No |
Post New Answer View All Answers
Is it possible to obtain 480v or 550v in single phase output by giving the input to 230v to a single phase torodial type transformer without using a stepup transformer?
diff.between servo motor and ac motor
what types of electrical & mechanical test conducted in switchyard?
Explain the iniluencc of short circuit ratio on the pert'orniancc of synchronous machine.
As per standard, transformer body earthing and other Equipment earthing (Equipment earthing) did not connect. but in LT side termination we are doing metal glanding in both side Transformer to PCC Panel through armoured cable, now X'mer body earthing and PCC Pane earthing (Equipment earthing) both are connect.is this safe for X'mer or other equipment?
how to calculte capacitor range for single phase induction motors??pls tel
what is the use of Auto re-closer?
PLEASE TELL ME ABOUT QUESTION PAPER OF UPCL ENTERENCE EXAM.
What does the term supermesh means?
WHY IN AC DRIVES,INPUT PHASE CURRENT SHOW UNBALANCE?
for a 500 KVA connected load, I calculated 30% of capactor for power correction. Even after using 225 KVR capactor PF is not improving. What could be reason for low Phase correction factor?
11000volt DG set carnt kaise banvay
What are the advantage of free wheeling diode in a full wave rectifier?
What is the difference between isolators and electrical circuit breakers?
What is the power factor of a transformer at no load?
