Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / hari prasad
When a metal is subjected to a load (force), it is
distorted or deformed, no matter how strong
the metal or light the load. If the load is small, the
distortion will probably disappear when the
load is removed. The intensity, or degree, of distortion is
known as strain.
| Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
HOW I SHOULD CALCULATE HEAT LOUD
Explain the principle of Suizer Fuel oil injection pump
On which analysis is based the dulong’s formula for the heating value of fuel ?
Why boiler is purged everytime before starting firing of fuel ?
what is critical temprature discuss that is any pressure greater than critical pressure is valid for boiler design.....2 in what cycle steam power plant is based draw h-s diagram.different process to make gear what is tooth profile what is generatic and directric and many more as i m doing mtech thats why interview was of 30 minute...........
What are the causes of dirty lubricating oil?
What are the different types of bearings?
pls tell me the process to set up a power plant right from the permission from state govt ????
My vendor filled liquid oxygen in our 11000 liter capacity tank. He filled from 1400 MMWC up to 3200 MMWC. I followed the provided conversion table and found that we had been supplied 1800 MMWC liquid which is going to yield 2815 cubic meter. On the other hand, the vendor claims that he supplied as follows:- 5236 cub mtr(3200 MMWC)-2124 cub mtr(1400MMWC) = 3112 cub mtr. I fear that he wants to charge 297 cubic meters extra. He claims that my method was wrong and his was right. He says that this disparity is because of the conical shape of the base of the flask. I will be thankful if somebody can explain me the truth.
Name the gauges?
How would you increase the volume efficiency of centrifugal pump?
can i get Mahagenco sample question paper?
sir, i am completed in diplamo. can i join in iit, anna univercity as lateral entry. pls reply me sir.
how to design a crankshaft?
Hello, I am PRAVEEN, working with start-up company as design, I don have any sap experience. but I wanted to join mm course in atos. Is it good change domain?
