Why in a three pin plug the earth pin is thicker and longer
than the other pins?
Answer Posted / rakesh
The above answers for why it is thicker.
It is longer because the The First to make the connection
and Last to disconnnect should be earth Pin. This assures
Safety for the person who uses the elctrical instrument.
Is This Answer Correct ? | 161 Yes | 29 No |
Post New Answer View All Answers
Tell me the reason of connecting domestic t/f primary in star or delta,and also secondary side.
there is an alternator 480 k.w, 400v,50hz, 4-wire running on load having leakage alternator body earthed current 38 A. is it within acceptable limit? if yes then give reference if no then how to bring within specified limit
How to megger test 11 kV cable and the acceptance IR value
what is difference between earthingpits,earthing grid & earthing mess?
Why is tan-delta test and capacitor measurement done on alternator?
how to failure indution motor insulation & how to improve heat in motor insulation
where the lexical paramater will use in fron end?
How many sprinklers should be in one pipe line?
Explain the operation principle, advantages and disadvantages of the following converters: a) A 12 pulse converter b) A Switch-mode inverter c) A thyristor inverter
What is Primary And Secondary Injection Test of Relay and Other Electrical Devices. How IT is carried out.
upto how much low RPM we will run the commercial motor which is run through VFD without any problem occurs in motor.Motor rating Duty is S1 & RPM is 1400.
What is meant by cold loop test in instrument
can any one know is sbi interview based on merit or based on roll number
1.how many types of relays? 2.difference between ATS& STS?
Maintenance of transformer???