Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / cipriano
A valve Positioner is a device used to increase or decrease
the air pressure operating the actuator until the valve stem
reaches the position called for by the instrument controller.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
Explain an adaptive / self-tuning controller’s major draw card.
what are the definitions of input, output, command & signal according to instruments controlled by PLC using DCS System?
What is eddy current? Describe the operating principle of proximity probe.
Who to difference between analog in & analog out in dcs?
How to find out the current of two motors having same power consumption but different RPM?
What is hp & mp seperator .& what is its working principle ?
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
Explain the key components of control loop?
What are different type of instrument cable
Can any one tell me what type of question asked for instrumentation and control interview panel??? pls mail ramashankar.goel@gmail.com
what is a good line as ic engineer as maintenance ,oc, project, calibration ,validation engineer?
why we use cascade control and feed foreword control in 3 element control of boiler drum ?what is feed forward and cascade control system ?
Why plc require in analog input 4-20amp & 0-10 volt?
How the warning lamp of a charging-system is activated ?
