Interested to Buy Any Domain ? << Click Here >> for more details...
What is diffrence between Transducer and Transmitter?
- 13 Answers
- 27407 Views
- Ford, I also Faced
- E-Mail Answers
Answer Posted / banibrata mukherjee
Transducer:It is a device which converts one form energy
(physical quantity) to another form of energy(normally
electrical quantity).
Transmitter:It is a device which converts the sensor output
into a form suitable for transmission over a large distance.
| Is This Answer Correct ? | 68 Yes | 3 No |
Post New Answer View All Answers
What is 3 selection available when configure the burnout protection for controller
Which are all the commonly used Bordon tubes in the pressure gauges. Do any one use ASTM A 312 tubes for this purpose?
Specify eight technical requirements that you would consider important, when deciding upon a particular control valve?
Which type of diagphram use in costic line,DM water line,natural gas line,oil line?
Sir,I am going to sit for IOCL written test exam. recently.Can anyone tell me the name of 'Objective type Question Book on Instrumentation Engineering ' which will help me. Pl. mail to bidyut_71@rediffmail.com / bidyut.saha2008@indiatimes.com / bidyut.saha09@yahoo.in
What are the key features of a Distributed Control System? describing the various layers (sensor through to business system interfaces) as well as the hardware, software and security aspects of the DCS.
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
What is the minimum rating availalbe for weld neck orifice in market?
where proximity sensor installed on tank in loading arm application
Why ac supply load cell is used? Can we use the dc supply load cell?
How vortex sensor used for steam flow measurment can be checked on line i.e without taking out from process line.
Galvanizing.
IN CONTROL VALVE SPECIFICATIONS GENERALLY TERM " DE- 200" ."DM -400"USED,, WHAT IS DE/ DM STANDS FOR?
hi friends,im an instrumentation and contol engg student,can u hlp me of suggsting barc written question paper,my id is roysuvaranjan@gmail.com, cel no.9563591747
What is the calibration procedure of Drum level transmitter if range is 0 to -400 mmh2o in lab?
