Interested to Buy Any Domain ? << Click Here >> for more details...
Why DC excitation is used for alternators? Why cant it be AC?
- 35 Answers
- 79348 Views
- ABB, Ace Info, Alstom, Shalivahana Power, I also Faced
- E-Mail Answers
Answer Posted / ashish
as we know that alternator work on the fraday's law ie when
a conductor cut the magnetic flux then a emf is induced. If
we give a.c supply than flux will also alternate and we will
get proper cuts of flux. hence we use dc supply.
| Is This Answer Correct ? | 3 Yes | 11 No |
Post New Answer View All Answers
What is the rate of WCT on the Electrical Contracts comprising of DG Sets and Civil Works in Delhi ?
what is the principle of the single phase energy meter? and,what is the advantages and disadvantages of single phase energy meter?
can i use 2000/5A Clamp meter to measure HT cable
how unidirectional torque is produced in DC motor?
What is value of earth resistance required for substation and equipment earthing and what are the reference guidelines
A double circuit with dog conductor 66KV Transmission line from wind farm evacuation to feeding substation having capacity of 25MW for transmission. Can same transmission network be considered for further expansion of Power & how much in MW. If we need to expand next 10-15 MW more will there any augmentation is required in transmission network? Kindly reply asap.
Classify drilling machines.
how to design the heater in temperature control unit to heat 50KL of water?
transformer spections :: input voltage 0-110-230v; output volage 0-10-12-14v; amp=3A using CRNO CORE, capcaity=50VA primary turns = ? ; secondry turns =?
why electronic instruments is more favorable than electrical?
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
pls,send the previous year written test questions.
How to size Air Circuit breaker (ACB)? What is the most important factors?
How are load losses and no-load losses measured at site in a DG set?
how to calculate power consumption in slip ring motor at different step
