Answer Posted / v.chandrasekharreddy
slip is defined as the ratio of difference between
synchonous speed(Ns) and actual speed(N) to synchonous
speed.
S= Ns-N/Ns. and
percentage slip=Ns-N/Ns*100.
| Is This Answer Correct ? | 10 Yes | 1 No |
Post New Answer View All Answers
why ht cable end termination don't have a gland?
Can you any one explain application of buccholz relay operation and pressure relif device operation of power transformer
how to calculate sizing of NGTR (Transformer rating,Loading resistor value and Current rating of resistor) and what is the X/R ratio. Details : 11kV,Capacitance 1.73532 micro farads,40kA for 1sec.
work of choke in florocent tube circuit ?
what is Anti-pumping?
State the types of distortions in amplifier?
In a Impedance Based Distance Relay (Quad Characteristics) - Could there be two different Line Angle(RCA) for Ph-Ph & Ph-Gnd? If So Kindly Let me Know.. Where, What are the advantages of the same?
What is use of starter and choke in tube light
what type of questions are asked and howmwny questions belong this catagory?
What is the test block protection relay if any body know plz explained
In case of generator when we consume more power produces by it why load on generator increase and starts sound more. and how it is adjusted..
there is an alternator 480 k.w, 400v,50hz, 4-wire running on load having leakage alternator body earthed current 38 A. is it within acceptable limit? if yes then give reference if no then how to bring within specified limit
how we can adjust for three phase motor cold stall time ,hot stall time and thermal register set up?
33kv substation lay out details & line to line & line to earth measurements
types of central Air conditioner plant?
