Answer Posted / anil kamat
Boosters in pneumatics are like converters of high volume -
Low pressure fluids to Low Volume high pressure fluids .In
simple words volume of fluid at entrance of booster will be
high and pressure will be low and at the exit of booster ,
the volume of fluid will be low but pressure will be very
high , as in case of Air brakes in buses or trucks.
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
can any one send me all the interview questions and test questions on strength of materials . to devarajk23@yahoo.com
What are the causes of failure of boiler tubes ?
why viscosity is measured in kinematic viscosity.?
What device installed in the F.O. system when excess oil return to drain tank?
What are the important operational performance parameters in design of fuel firing equipment ?
Define convection.
HOW LIGHTENING PROTECTION IS DONE ON ROOF OF SQUARE SHAPE AND HAVE PARTUCULARLY BIG SURFACE AREA.
What parameters to be reported when we send lubricating oil for shore analysis?
i want to know the difference between proportional hydraulic valve & servo hydraulic valve
What is a feed water pump? Dearator feed heater?
Steering handle (round dial) of motor vehicles (CAR,BUS,LORRY) wiil be designing with two cross supports without 180 degree straightness( it will be little bit cross). Why?
what is the three phase induction motor? what is difference between motor used in household instruments and induction motor?
how to solved the crictical problems in d. g. set
What is g.i.?
What does a rolling offset look like?
