Interested to Buy Any Domain ? << Click Here >> for more details...
which trsanmission is easy and cost effective AC or DC.
- 19 Answers
- 20808 Views
- I also Faced
- E-Mail Answers
Answer Posted / av
Please! Only AC is the good answer.
If you look from the high-voltage line (kV), it's the AC we
use and is AC 3 phases (shift 120° each other). From math
perspective, we can send much more power by using a
"smal" (let's say 1 inch) cable.
It's easier to transforme AC to DC. From DC to AC, you will
need more sophisticate hardware (like microControler) to
have a beautiful sin signal of AC.
AC is easier to transform to any level of voltage we want.
The DC, there is more lost because the line has a resistant
and bcause the voltage is always stable, well there are
power lost from P=V*V / R. The AC is less than that.
| Is This Answer Correct ? | 4 Yes | 11 No |
Post New Answer View All Answers
what is settable hystersis protection? If any body knows plz kindly post the answer..
how does the terminal voltage of transmission lines increase when a capacitor is connected???? This happens not only in transmission lines but also in all circuits. How??? When a capacitor is connected in a transmission line, capacitor also takes energy from the same supply. But how is it able to increase the terminal voltage??? Practically What sequence of events happen during increase in voltage???
HOW TO CALCULATE THE VT SIZING?
design a 3 bit synchronous and asynchronous counter using T- flipflop
The metal-enclosed switchgear and controlgear is subdivided into three types: 1. metal-clad switchgear and controlgear; 2. compartmented switchgear and controlgear 3. cubicle switchgear and controlgear. What is the main differnence between them. State some example.
Does all the output contacts (N/O as well as N/C) of a Numerical relay operate when relay receives a binary input/inputs or contacts are designated to specific logic input/inputs and only these contacts operate?
Can we use 230VAC, 63A MCB for 120VAC, 63A supplied heaters load?
2. What are the parameters of EHT sub-station?
Explain the process of commutation in a dc machine.
errection check list for transformer maintenance
I have done my m.tech in electrical engg discipline. Can any one please suggest me how should I prepare for getting into phd in iit or nit.How should I prepare for getting into lecturership
What are the basic component of a cro?
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
The knee point of a current transformer is normally unique and known.So why in the nameplate of a CT they put the minimum value like this Vk> 400v.
What is the difference between AC and DC injection methods for rotor earth fault protection
