Why fuel tanks to be earthed ?
- 6 Answers
- 18270 Views
- Electronics, Hindustan Petroleum, HPCL, Ispat, I also Faced
- E-Mail Answers
Answer Posted / moti rgpv
THE BODY OF FULE TANK IS DIRECTLY CONTACT WITH AIR . THIS
AIR INCREASE THE IONAITION LAVEL OF TANK.SO THERE WERE
CHANCE OF ACCEDENT.
TO DECREASE THE ION ON BOADY IT SHOULD EARTH
| Is This Answer Correct ? | 49 Yes | 16 No |
Post New Answer View All Answers
State uses of different types of stsrters with different capacities of motors as below: a. up to 5HP b. above 5hp to 10hp c. above 10hp to 20hp d. above 20hp
How many devices can be connected in one zone of FACP
why we use copper earthing for neutral while for body GI.
What is Percentage impedence of a transformer? why it is expressed at a percentage? what is the importance of percentage impedence in case of a transformer?
in battery charging room we find two fuses (one in positive other in negative cables ).why it is so?one fuse is ore than sufficient?
Define average demand?
Why L.T.Cable voltage rating is 1.1kV,where as system voltage is 0.415kV?
What is meant by time harmonics and space harmonics?
What is the drawback of class b amplifier?
what is harmonics? what are the factors it will depend upon
What is the difference between diesel generator engine with and without turbo charger with the same capacity?
What is the diff. between single compression and double compression gland
Any one can explaination about calibration with rotating sub standards?
11kV capacitor bank of rating 2.4KVAR, is charged with protective relays of only over current & Earth fault &.......without Over Voltage, Under Voltage & Neutral Displacement Relay. Is it advisable??
Can double compression glands be used with regular cables?
