why nearly all voltages are in the multiples of 11?
- 5 Answers
- 8451 Views
- I also Faced
- E-Mail Answers
Answer Posted / shiva
May I know the relationship between form factor and
generated voltage????
| Is This Answer Correct ? | 0 Yes | 5 No |
Post New Answer View All Answers
is it value of power factor is more than unit. whats effects in the source supply
design a LV scheme for a 15 storied building?
Why water bubbles when D.C. Current is passed through it? Why not when A.C. Current is passed?
I meggared my 2c*70 sq mm AL AR XLPE cable. its one end show 50 M ohm . is my cable is safe for laying. I have only one phase and neutral.
What are stable systems?
Could u pls tell me the NPCIL electrical engineering interview questions for Executive trainee, and also guide me how to face the interview.
what is the difference between electrical choke and electronic choke?
how to generator maintenance (A Check, B check,Etc)
what is the circutor?why we use it ?
Explain the laying procedure and laying depth of submarine/subsea power cable for 220/400KV system? Also available cable diameter?
What is the formula to calculate the rating of a three phase air circuit breaker
What is open loop and control loop systems?
How to calculate the Harmonics losses in terms of cost/unit.
Greeting to all members, How to calculate spill current when we have different ratio CT and Class for REF(Low Imp) I have 500/1A 5P20 @line side n 400/1A CL.X @ Neutral.
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero
