what is the highest transmission voltage in india???
- 49 Answers
- 47444 Views
- Bhel, EIPL, Engineering, Jindal, I also Faced
- E-Mail Answers
Answer Posted / thir
500kv dc ,765kv ac
if any doubt visit http://www.cea.nic.in/power_systems/
National_Electricity_Plan/Chapter_1_Introduction.pdf
| Is This Answer Correct ? | 23 Yes | 20 No |
Post New Answer View All Answers
What is the permissible limit of shaft voltage for 6.6 KV motors ? Why? Is there any standard is available?
How to calculate mf when meter equipment and meter are connected
Cb closed condition if there is a tcs fail whether cb will trip or not
How to protect sensitive loads such as Dosing pumps inside a factory from voltage surge/voltage fluctuation.
What is the difference between a Root Locus plot and a Bode plot?
I have a drawing of a wound rotor induction motor for a crane. This crane motor has 5 forward speeds & 5 reverse speed implemented of course with different amount of resistance for each speed setting selected. What has got me scratching around is the fact that 8 of the 10 speed selections switch in uneven (unbalanced) amounts of resistances on each of the 3 connections to the motor's rotor.Can this be possible? I would have assumed this would produce unbalanced rotor currents and therefore vibration in the motor. I would greatly appreciate anyone's comments on this. Many thanks, Confused.
electrical ques
what is d check in dg 1500kva
Give accurate definitions for these electric terms: Inductor Inductance Inductive Induction Reactance Reactive Esam Baraka ٢١ ساعة
how to select the no. of brushes in a lap winding?
i am going to give the JSEB,RANCHI exam for power plant,so i need some samples of papers related to that,so please send me these papers by my mail id.
i have seen one 8.4 MW synchronous motor in a plant located in bellary it is fixed with brushless rotary rectifier ,anybody can explain its start up principle
How to calculate no of EARTH PIT? Describe the formula as per IS standard?
What is the height of DA, DAL, DB, DC & DDE tower?
bus bar design conditions and sizing pls tell me quickly
