Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / moti rgpv
THERE ARE I*I*R LOSS IS RESISTIVE COIL WHICH IS ONLY
RESPONSIBLE FOR HEAT INCRIMENT IN X-MER
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
what is the difference between linear choke and suction choke?
What are the causes of having an rmu explode after installation? And how do u treat the bushings of an rmu?
what is meant by LCR meter? where its useful ?
A 100 kVA , 400 v/250 kv testing transformer has 8% leakage reactance and resistance on 100 KVA base . A cable has to be tested at 500 kv using the above transformer as a resonant transformer at 50 hz . if the charging current of the cable at 500 kv is 0.4 A find the series inductance required . Assume 2% resistance for the inductor to be used and the connecting leads . Neglect dielectric loss of hte cable . what will be the input voltage to the transformer ?
H.t motor 6600 volt to same motor lt supply 440volt supply applyed to h.t motor to effect....
The advantages of Magnetic flux leakage technique over Ultrasonic technique for non distructive testing of material.
What consists of 2 or more thermocouples to be connented series?
What is the minimum distance to be maintained in between HT panel and LT panel and Instrument panel as per IEC and NEC standards?
For group 1 , 2 whather i have to prepare my technical or general studies etc? and im graduate in ee engg. for wht posts im eligible for? please tell me!
In a power conditoining unit (inverter) of a solar plant when we measure the d.c. current fed by different strings of solar plates to inverter, the current in the negative wire is less almost by 1 ampere to the current in its positive wire say current in positive wire 5 A , then current in negative wire of the same string is 4 A. Since the current entering should be equal to current leaving then why the current is noticably less in negative wire.
how does this job compare with others you have aplied for?
If i am running of spindle at 2000rpm ,but How to spindle stop at the second I am resetting the machine in CNC machines
What are the two types of compensation?
ht side line to earth voltage
why high speed tripping relay will be used in tripping circuit why not normal relay
