why twisted pair of wires is used in instrumentation ?
- 6 Answers
- 22040 Views
- ONGC, I also Faced
- E-Mail Answers
Answer Posted / ibrahim s
Application of Twisted Pair Cable:
*Twisted pair cabling is a form of wiring in which two
conductors are wound together for the purposes of canceling
out electromagnetic interference (EMI) from external
sources.
*Twisting wires decreases interference because the loop
area between the wires is reduced.
*The two wires typically carry equal and opposite
signals which are nutralized because of phase shift.
| Is This Answer Correct ? | 59 Yes | 1 No |
Post New Answer View All Answers
What is modbus?
Difference between dcs and plc including date processing and architecture.
How can measure flow in oil line?which type of transmitter is generally used?
what are the diff. in servo and regulatory control?
any questions on motor and energy conversions machines?
Explain the working of an enraf level gauge.
what is the input of digital counter during the the calibration time?
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
Can please tell mi about SIOS, PRM, SERVER, and what is the diference between PIN LAN, PCS LAN,APC Server, and please send the Doc if possible for referance,mail id patil_amit17@yahoo.com
god evening sir i am studying m.sc(tech)electronics &instrumention.am i elegible to all industies
please can any one tell me clearly about pid tuning i am confusing about this .how to tune pid easly?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
Operational amplifiers
What are the different types of thermistors used in industries? How to the operation of typical thermistor?
How to work temperature gauge?
