Answer Posted / n.rajasekhar
hi,
ohms law work for DC as well as AC,butu have to apply for
a single electrical element at a time.lets say apply for TF
primary winding,then based on the applied voltage and
induced volate and winding impendence u can find supply
current.like that for secondary also.where you got wrong in
this.I guess u might have applied ohms law for both primary
and secondary at a time.
Thank you
Is This Answer Correct ? | 19 Yes | 18 No |
Post New Answer View All Answers
Hi.. I am a BE GRaduate in E&E. I have 8.5 Experience in Tendering & Estimation field. I have done SAP SD course few years back. But due to some reason i failed to get job in that field and continued my own field. Now I am thinking of changing into SAP seriously. How should i go ahead???
What is CCM in Electrical ? where can we use this material?
What is the main purpose of c.f.b.c.boiler
HOW WORK HEAT PLATE EXCHANGER
Some times to change of DOR of a motor, interchange of R & B is not effected and RYB take same current, but interchange of R&Y is effected ie change the DOR. My doubt is what is the problem in motor and how it is happen.
dear sir/madam i want to get some knowledge about RRB EXAMINATION(section engineer) 1- what is minimum cut off 2- wht portion is major portion . 3- can any body provide Sample paper. thanks & regards ashish
it is in our knowledge tht right plug of supply of residential suppy system is phase n other is neutral...howevr the battery charger of mobile works in both ways...i mean it is not restricted in only one direction.ny of the holder of charger can hav phase .so y is it not lik tht phase of supply must b connected 2 phase of charger...?
What is inverse definite minimum time lag relay? Where is it use?
What is the difference between diode and a transistor in terms of the direction of current flow?
How can we decide cable size from HT panel to Transformer? Please give you reply with some examples.
Why two phase welding machine is used instead of three phase welding machine.
What is the basic rule for block diagram reduction technique?
what is meant by star/delta voltages as 440/220 in a 3 phase induction motor, and why it should be connected on STAR IN 3 PHASE SUPPLY
what is the eight bit unit?
please send me previous year questions of jspl through which i could prepare myself for the test.