Technician A says that a fuel tank sending unit will have a
high resistance only when the tank is full. Technician B
says that its resistance when the tank is full depends on
whether the sending unit is designed for use with a
bimetallic gauge or with a magnetic gauge. Who is correct?
- 3 Answers
- 9964 Views
- I also Faced
- E-Mail Answers
Answer Posted / boopalan
The questin is not clear, pls post a clear question.
The resistance means which resistance?
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
Questions on flow meters,few questions on HART protocol,
any one can send me instrumentation previous interview papers? I prepare for MNC Company Interviews? my mail id- Rakesh.Golla@dodsaldxb.ae , and another mail rakesh.gvk@gmail.com
can any send me a forbes marshall dtron 316 manual
Question on maha cement
i hav applied for the post of engg. in iocl so please require the past test papers fro instrumentation engg please please help me and send me the papers or tell me the pattern and type of ques asked in examination......
hi sir yhis is zahid ali i am preparing for the jspl at oct.4.please send me the recently updated sample paper.
What are the key features of a Distributed Control System? describing the various layers (sensor through to business system interfaces) as well as the hardware, software and security aspects of the DCS.
plz send me general of ongc
any body please send me the old question papers of ongc test.
can any one tell me when ongc placement test and its forms is available????/ pls tell me if u know
send me model hpcl questions pleas..........my mail id mohideen.dharvesh@gmail.com
principle of dead weight tester ?
DEAR SIR/MADAM MY NAME IS ARKAPROVA BHATTACHARYYA.I AM A FRESHER INSTRUMENTATION ENGINEER.CAN YOU PLEASE SEND SOME QUESTION PAPERS OF GRADUATE ENGINEER TRAINEE EXAM OF DVC(DAMODAR VALLY CORPORATION).MY EMAIL IDs ARE arka_aec@rediffmail.com.
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
What is the Working principle of Dozing valve?
