Interested to Buy Any Domain ? << Click Here >> for more details...
Is there a particular problem if two proposals from the
same observatory (originating with different partners) are
submitted?
- 1 Answers
- 3725 Views
- I also Faced
- E-Mail Answers
Answer Posted / harish
Skin type thermocouple is one that is welded in place and
does not get moved around. a regular thermocouple is
usually moved around or placed inside a thermowell and the
grounding is when the wires are welded to the sheath
material and ungrounded is not. This is the difference of
these two types.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
why we take %i0.0 as input for twido plc
How to Calibrate Ultrasonic Level Transmitter in field
you are on site,the plant trips,you are approached by operations,what do you do?
How to calibrate radar type level transmitter for interface level? Total liquid(liq.1 and liq.2), level both the liq individually? For. Both the liquid levels how the signal will go from transmitter to dcs? How to calibrate. Single radar 9:26:55 AM for 2 different liquids in a tank?
What are different types of control valves?
what is sil (safety integrity level
What is feed factor and its Importance in cement industry? How we can solve feed factor?.
Explain the mechanism behind the turbine meter.
What happen if I install my pressure transmitter below the elevation of pipe in natural gas service?
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
Do you have reference list?
what is use of communication wire in multipare cable(oil and gas field), why this communication wire not used in single pair cable?
what is orfics working in main steam line. is it increase pressure, velocity of steam flow and dicrease steam flow rate. or any other
how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?
Calibration of controller (pneumatic)
