Interested to Buy Any Domain ? << Click Here >> for more details...
why the power cut problems occur in tamil nadu?
may i know the exact reason.plz
- 17 Answers
- 29313 Views
- I also Faced
- E-Mail Answers
Answer Posted / jack
No Proper Maintenance
Distribution method
| Is This Answer Correct ? | 102 Yes | 27 No |
Post New Answer View All Answers
why magnetising curve not start with zero voltage?
How to calculate multiplication factor in kva example 500kva ans pls ?
Why different Pressure switch used in marine boiler water circulation system
How many types of losses occur in a transformer?
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
what happen if generator of micro hydro running at only a small percentage of its capacity, as a comparison, if the diesel generator that runs on only a fraction of its capacity there will be a wet stacking
can u please mail me the syllabus for GET exam for damodar valley corporation?
Why 30kw 40 hp 4 pole 3ph induction motor over heated?any steps on reduction in heat?
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
If the earth is a good conductor of electricity, why don't people get shocked every time they walking on earth?
A 100 kVA , 400 v/250 kv testing transformer has 8% leakage reactance and resistance on 100 KVA base . A cable has to be tested at 500 kv using the above transformer as a resonant transformer at 50 hz . if the charging current of the cable at 500 kv is 0.4 A find the series inductance required . Assume 2% resistance for the inductor to be used and the connecting leads . Neglect dielectric loss of hte cable . what will be the input voltage to the transformer ?
The 3 phase Delta connection RB=440V, BY=350V,.......* is Line to Line voltage RY= ? And Formula....?
Will an earth leakage trip be activated if the component or wiring is faulty on low voltage equipment.Example An electrical Cat Scarer placed in the garden and water gets into the wiring.
what happened when we supply a dc current in dc motor?? can it worked properly?
why is using sensor?what is differece between photoelectric and proxmitty?
