Interested to Buy Any Domain ? << Click Here >> for more details...
why the auxilary(starting)winding is provided in single
phase inductoin motor?
- 5 Answers
- 7571 Views
- I also Faced
- E-Mail Answers
Answer Posted / senthil
because single phase motor is not a self starting,and its
starting torque is small,and it will rotate 90 Deg phase
shift only,For 360 Degree rotation starting winding is need
due to high starting torque
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
can we install HT panel & LT panel side by side or how much clearance is required ?
How to calculate the Harmonics losses in terms of cost/unit.
why current flow to the opposite direction of flow of electrons???????????
A commercial Building is designed with 14th floor levels with indoor substation of three phase transformer with rated capacity of 1000 Kva.The transformer delivered 65% of its rated capacity at 0.67 power factor lagging.Because of low power factor, the power customer was penalized and certain cost was charged accordingly based on every point percentage lower than 85%.This situation may repeatedly happen on the succeding energy bills of power customer.The power customer is desired to improve its historical power factor of 0.67 lagging and no further penalty be impose by the local power company on the next bill. Q: Identify the appropriate solution you want to offer to Client?.Justify SCIENTIFICALLY and MATHEMATICALLY the principles behind the solution.
errection check list for transformer maintenance
what are the difference between PLC and embedded
At the starting of dc motor and syn.motor and induction motor high current flowing through the winding. Due to this the windings burnt out. To avoid this different types of starters are used. But incase of transformer what Will be used (At starting no emf is induced in the primary winding)?
There is any especial requirement for motor to drive through with VFD?
1) Explain why we don't link the two earthing system ht and mv on a pole mounted transformer sub-station.
Why the moulded plug comes with domestic appliances instead of assembled plug like anchor, Vinay 5/15 A.
i want to put single phase load on scott connected transformer,eventhough how to balance the transformer.
Whether power factor should be high or low? Why?
How to calculate energy stored in a capacitance
What is the ratio of Booster transformer?
why single CT used in DOL starter power circuit?
