Interested to Buy Any Domain ? << Click Here >> for more details...
A 3 phase motor, 440 voltage, induction motor. If we take
out rotor from motor and if we give supply 440 volt to
stator then what happens?????
- 20 Answers
- 23262 Views
- I also Faced
- E-Mail Answers
Answer Posted / vijay
Mr. Gajanan, then motor why not burnt when rotor is
inserted, whats the cause between rotor inserted and rotor
out????
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
What is difference between start imitation and start interlock for 3 phase motor protection ?
what happend to DC shunt motor if its field winding insulation becomes slightly weak? will that motor can run on full load or not explain in detail. thanks
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING) I O (current operating)?
How to do cable sizing calculation for 750 A Neutral Earthing resistor for 33kv. the 33kv cable going to swbd. is 630mm2 3 runs.
High voltage test procedure of in swgr board. why should measure millivolt drop on testing time?
what should be the no load current for 3 phase ac motors ranging from 5 kw to 1000kw?
how to electronic energy metter failed in electomagnectic fild passing in the metter and which thing to defect more on metter.
Define early construction of human being
how can calculate 1kva generator running time in 1 liter keroscene
pls tell me about ups internal connection & we have given only 3 phase supply to ups system how get 4 wire (R Y B N )
which mm cable should be used for 1.hp immersible pump motor for the distance of 330 metres?
Pls explan the OLR setting in VCB at HT yard
placing earthing pit in pathway is correct or wrong??. placing earthing wireGI1/18 inside walls is correct or wrong?. explain!!!
how to calculate IR value of 33KV cable ??
