Interested to Buy Any Domain ? << Click Here >> for more details...
A 3 phase motor, 440 voltage, induction motor. If we take
out rotor from motor and if we give supply 440 volt to
stator then what happens?????
- 20 Answers
- 22765 Views
- I also Faced
- E-Mail Answers
Answer Posted / aju
Since the stator winding has sufficient reactance, it will
not burnout and nothing will happens...
| Is This Answer Correct ? | 13 Yes | 14 No |
Post New Answer View All Answers
Why we use auxillary relay ? what is function of differential relay, directional o/c relay?
We have 90mX100m hangar with 16 no.of supporting pillar. It is required to provide power supply on all pillars. what is suggested earthing scheme for hangars.
how to calculate regulation constants for over head lines? and what are the regulation constant for raccoon conductor at different voltage level and different P.F?
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
all interview questions with answers of ntpc (2000-2009
what is the difference between directional & non directional earth fault with example please explain.
What kind of maintenance is conducted for Transformer
What is NGR . What is the purpose of 10 sec ,60 sec rating of NGR.
how i chosse capacitor bank if my energy meter is 48 kvr? tell me capacitor bank chossen formula?
what is the differation bewreen kwh & fundamental kwh in electronic trivector meters
If the rated speed of a d.c. Shunt motor is1440 r.p.m, which method of speed control would you suggested to obtain a speed of 1500 r.p.m?
Can we indroduce the principle of single phase induction mator to Transformer? i.e. by Producing rotating flux in the transformer.
Which types of gate insttaled in static switch. Please give me answer.
i have to install a HT panel, what components, I have to use in this and what will the diagram of that diagram,please tell me each and everything.
How seriving & testing of the HT & LT breakers are done. What are the standard Ir values on which we can come to know the test is passed or failed?
