In a 11000/440 V transformer, when any one phase of 11 KV
supply fails (ie., single phasing), what happens to the
secondary voltage and why?
Answer Posted / pravesh
if the 11kv /440 v supply if one phase fails then at that
time open delta circuit takes place in that case the for
which the equipment connected to the secondary side , 440v
side will work below their efficiency
| Is This Answer Correct ? | 9 Yes | 14 No |
Post New Answer View All Answers
hello everybody. what does an abnormal stator winding impedance or dc resistance show? thanx
mostly the questions were from machines... d.c. machines, transformer, synchronous and induction all theory paper........ few from power system... but the level of paper was easy.....
why occ characteristics of generator is also called as magnatization characteristics ?
Does all the output contacts (N/O as well as N/C) of a Numerical relay operate when relay receives a binary input/inputs or contacts are designated to specific logic input/inputs and only these contacts operate?
How much pf maintan in dg set in 6o% load,when Dg runnig Neutaal Earthing removed what happen.
what is the pulse and audio frequency transformer? what is different between induction regulators and tap changing transformer?
what is the transformer rush current?
WHAT IS SUBSTATION & ACCORDING TO VOLTAGE HT,EHT SUBSTATION EXPLAIN IT
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
1. A bomber drops a bomb from an aircraft flying at 2000 km/hr. at an altitude of 7km. The speed at which the bomb will strike the earth would be
what causes contact chatter when there is no demand on the air conditioning unit?
Explain the operation of variable frequency transformer?
what is the use of piston rings in the engine used for a generator...........
IN MY SYSTEM THERE IS ONLY OVER CURRENT EARTH FAULT RELAY IS AVAILABLE. FOR THE UNBALANCE SENSING IS THERE ANY RELAY IS AVAILABLE? THE SAME CTs WHICH ARE USED FOR THE OVER CURRENT EARTH FAULT RELAY CAN USE FOR UNBALANCE ALSO?
what is a pilot wiring and whys that called a pilot wiers