Interested to Buy Any Domain ? << Click Here >> for more details...
What is the result of under frequency to the system.
- 4 Answers
- 13168 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
since the system is designed with a standard frequency say
50Hz or 60 Hz, if the frequency goes low, the following
effects will happen:
1. induction motor will run with low speed and consume more
current.
2. transmission cost/losses will be more.
3. capacitive reactance will be more.
4. metering device will record more power
| Is This Answer Correct ? | 22 Yes | 0 No |
Post New Answer View All Answers
How can we find the breaking capacity of a Load breaker switch (LBS) fed from 11 kv supply??ex:50KA, 26kA etc???detailed step vice answer pls.
ht side line to earth voltage
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
i have 500 amp inductive load of motors ,,,pleas tell me how can i calculate for capacitor bank for improving my power factor to 99 .....calcullations for capacitor bank,,,,
Briefly describe your ideal job?
How does HT work & Voltage required?
Currently what is the highest capacity (MVA) of SPPg generator available in the market?
What is the difference between PS & metering CT (5p20,0.5 etc.)? Why in PS class CT only Vk is given ? Is PS class CT is more accurate than metering CT?
what is mean by NPS (Negative phase sequence)fault? what is the difference between EFR & OCR faults?
why single CT used in DOL starter power circuit?
Starting current of a 10 HP induction Motor is ______ time’s full load current.
please send me the L&T Emb. sys. placement papers and entire details of pattren
What is reactive power and where it is used.
block diagram of 2 ups system connected in parallel mode?
In a carnot engine with an efficiency of 40%, the heat rejected to the sink at 27 C is 60 kJ, then the heat supplied in kJ to the engine by the sources is
