Interested to Buy Any Domain ? << Click Here >> for more details...
Can any body help me,The GE Mark V control system is
windows based or Dos based?
- 3 Answers
- 7320 Views
- I also Faced
- E-Mail Answers
Answer Posted / naren
DOS BASED
| Is This Answer Correct ? | 18 Yes | 1 No |
Post New Answer View All Answers
what is the calibration procedure for transweigh make weigh feeder?
Can please tell mi about SIOS, PRM, SERVER, and what is the diference between PIN LAN, PCS LAN,APC Server, and please send the Doc if possible for referance,mail id patil_amit17@yahoo.com
Question on maha cement
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
how to calculate control valve bonnet size?? or how to select its material?
it is possible to check the fail safe condition in pressure transmitter. if possible how?
Which are all the commonly used Bordon tubes in the pressure gauges. Do any one use ASTM A 312 tubes for this purpose?
How u measure the massflow in orifice flow measurement techniques
few questions on RS 232,1 question on relationship of impedance and turns ratio, many questions on flowmeters
What is voltage regulator?
What is hp & mp seperator .& what is its working principle ?
Which Signal hart communicator work? If there any signal change when hart connect while transmitter in line ?
selection of the zener barrier for the hazardeous area zone 0
components of control circuit belongs to control valve
How flow can be measured with dp?
