Interested to Buy Any Domain ? << Click Here >> for more details...
what do you mean by 1 ton in AC`s
- 36 Answers
- 116180 Views
- Bhel, Bosch, ITC Infotech, I also Faced
- E-Mail Answers
Answer Posted / s.pushparaj
The amount of the heat required to convert 1 ton (2000
pounds)of ice in to water within 24 hours. The initial
temperature of water is 0 deg C.
Latent heat of ice= 144 BTU
1 TR= 144 X 2000
= 288000 BTU/24
For 1 hour
We can divid by 24 So 288000/24=12000BTU
1TR=12000BTU/Hr
=3024 K Cal/Hr
= 12600 K Jul/Hr
= 3.52 HW OR K Jul/Sec
| Is This Answer Correct ? | 89 Yes | 12 No |
Post New Answer View All Answers
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
l&t switch FN 63 handle position can we change
What are the limitations of Kirchoff's laws?
What is the diffrence (Technical & Construction ) between CBCT & Normal CT?
List the time domain specifications.
In ACS 1000 drive we are using 12 pulse converter,why don't use 3 pulse converter.
how load of a turbo generator can be increased
What is meant by harmonic distortion?
How can we calculate strength of copper hich is supplying electric power to heater and in it hold the heater also and what r all types of forces which is acting on it...
what is basic difference betmeen normal & flame proof motor??
How we can recongnise the phase displacement of transformer connection between primary & scondary...plzzz explain it with example.........
what is the main difference between power devices and signal devices
Which device of PlC does share load between DG sets when DG are running in perallel?
