Interested to Buy Any Domain ? << Click Here >> for more details...
what is the highest transmission voltage in india???
- 49 Answers
- 60775 Views
- Bhel, EIPL, Engineering, Jindal, I also Faced
- E-Mail Answers
Answer Posted / ramakrishna
11000v
| Is This Answer Correct ? | 8 Yes | 135 No |
Post New Answer View All Answers
Which Class insulation is prefered for the sandwich Busducts ? Why?
What is the control action?
design a LV scheme for a 15 storied building?
what is high and low cut off voltage of BB and DG at SPS????????
HOW CAN I GET 5CORE HO7 CABLE SIZE IF I HAVE 1800A?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
Define active filter?
area control error
Define demand factor?
what is the physical connection of a analog i/p to a analog i/p module (ab plc)and through a analog o/p module(ab plc) to a analog o/p . and how all the process control by scada
WHAT IS MEANING OF Gg & Gg IN hrc FUSE
what is a bus riser in power system and why it is used
Define pole pitch?
how to remover corona effect and hysteresis losses from contactor
Why 3 phase induction motor getting supply in body if one of it's phase is cut
