what are the affects of loose connection in electrical
circuit.
- 14 Answers
- 60327 Views
- HP, I also Faced
- E-Mail Answers
Answer Posted / rvg
A llose connection contact can produce following effects:
1. Spark b/w cable and equipment.
2. Damage of cable lugs.
3. Heating of any insulation nearby.
4. can ignite any inflamable material near by
5. voltage reduction b/w the terminals etc.
| Is This Answer Correct ? | 79 Yes | 6 No |
Post New Answer View All Answers
Why is the air gap between the pole pieces and the armature kept very small?
Why should be the frequency 50 hz 60hz only why not others like 45, 95 56 or anything , why should we maintain the frequency constant if so why it is only 50 hz 60hz?
Why IR value of the (HT cable Plus synchronous motor) is less while individually having IR values in GΩ?
i have total 8 dg sets for synchronizing and 2 buscoupler,1 sectoin dg no 1,2,3,and 2 sectoin dg no 4,5,6,and last section dg no 7,8 ....if buscupler no 1 and 2 is off mode ..than dg no 1,2,3,will synchroniz of another dg sets?
If two Transformers are connected in parallel having impedance of 50KA in both transformers will the impedance increase or decrease after connecting transformers in parallel?
What is polar plot?
What is servo motor and what are different types of servo motor
while doing high voltage test on 11kv/433 distribution transformer why we only give 28 kv on hv side and 3kv on lv side for power transformers what is the value what factors it depends
In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?
what is the relation between size of the anteena and wavelenghth of radiated wave
i have seen one 8.4 MW synchronous motor in a plant located in bellary it is fixed with brushless rotary rectifier ,anybody can explain its start up principle
What are the types of windings present in the ceiling fan? What winding will be effective first when we started the fan?What are the resistance and inductance ratios comparatively at the initial speed and full speed of the fan?
Can we check ELCB constantly from R1 to R8 phase in 1 no DB?
WHAT R THE SAFETIES IN A HIGH TENSION PANEL N LOW TENSION PANEL. ALSO WAT SAFETIES R THERE IN A 200 KVA TRANSFORMER?
How to measure the Harmonic Distortion of UPS ie THD?
