Answer Posted / faisul
carburater is a device which is used to mix the air and the
fuel at the required propotion........
Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
What are the two basic types of steam turbines?
sir i appeared to bosch written test recently and i cleared it successfully.can u suggest me how the interview will be done ?is it technical or HR or both?how shall i prepare for it?i am very eager to work with and in fact it is my dream job suggest me how to grab the job.if you know tell what type books are prefer for preparation of intrview?
Hello sir! I hav read the above discussions about PSU.I hav 72% aggregate in Mechanical bt i do had a back in 1 subject,so m i too eligible for PSU?
Is it the relation between friction and power losses ? is it relation among stress, friction and power loses in cicular ring ?
Hello Friends I had my ONGC test today,but it was very bad.But I would give certain suggestions so that u may not face he problem which i had. Be thorough with Electrical Technology.Generators.motors stators etc.There are 5 questions on that. There were also good no.of questions from Hydraulic machine and Production technology. Then 3 from Strength of materials.And remember the dimensional quantities.
Define a slined joint?
I need BHEL Engineer Trainee written test papers in Mechanical stream.
When effect of variations in specific heats is considered then how do maximum temperature and pressure vary compared to air standard cycle ?
What is torque converter?
What is isotropic material ?
A fan is handling hot air at 285 degC with flow of 411635 m3/hr, power consumed is 1165kW and efficiency is 66%. what will happen to flow, power and efficiency of the fan if a water spray system is introduced to reduce the air temperature up to 200 degC? (also please refer any document regarding this)
How does an equal-arm balance work?
When repacking a valve the rings of packing should be oriented so that the packing ends are installed ____________.
I need the complete syllabus and model Question paper for Written exam of JINDAL STEEL AND POWER LTD.,for MECHNAICAL ENGINEERING branch
Which is first stress or strain?