why heat produced at junction of two different conductor.
what care should be taken to minimize it.
- 11 Answers
- 14994 Views
- Birla, Maihar Cement, I also Faced
- E-Mail Answers
Answer Posted / vishnu p jariwala
Both conductors have differend impedance(Z),And Becose of
resister heat losses is accour That's why...
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How to calculate LT XLPE CABLE for 11 kv / 433 v , 1000 kva oil type transformer system?
It is desired to flood light the front of a building 42 meters wide and 16 meters hig.Projectors of 30 degree beam spread and 1000 watt lamps giving 20 lumen/watt are availabl.If the desired level of illumination is 75 lumen/m and show a suitable scheme.Assume the cofficient of utilization, deprecitation factor and waste light factor are 0.4, 13 and 1.2 respectively.
What is hipot test procedure?
how to minimize earth resistance upto 2Ω, if the resistance is 6 Ω ?
explain the process of commutation in a dc machine. Explain what are inter-poles and why they are required in a dc machine.
what is the effect of power factor of machines in starting current
what are different types of electrical windings? i know the distributed winding ,concentrated winding etc but i want some detailed information, in what condition we will use distributed,concentrated windings what are the difference between them which is best, how induced emf changes by using different types of windings 20 hours ago - 1 week left to answer
What is accuracy of a measurement?
Shall I use 40A semiconductor Fuses in 32 A SFU ? Frame size is same. What Happen if Fuses burn on SFU?
why should the lowest unit of a testing transformer ( cascaded transformer ) have higher power rating??
In parallel operation time both NGR’s close or not close if both close what will happen
how power trnafor from 1 point to another point in bus bar ya transmission line( voltage trnasfer from 1 point to another poin)
what is interpose? where it is used and why it is used?
What are the Full Forms of TVM, MTL, CVT ?
What are the special cables required for explosion proof wiring?
